LONG RANGE UPDATE APRIL 4/2016
The long range committee and one board member met with the Alberta CFO at the range April 4. Two separate long range (1200m+) proposals were reviewed on-site. Extensive dirt-work/construction would drive the initial development cost to $1000,000.00 +. Requirements for construction of berms and ground baffles are required. Due to the challenging terrain (muskeg and lack of suitable fill material) as well as the high power range template falling across David Thompson highway the proposal has been permanently scrapped.
IMPORTANT CHANGES FOR 2017
1. MEMBERSHIPS WILL BE SELLING AT TACKLE AND TRAILS IN ROCKY MOUNTAIN HOUSE
2. Electronic gate system to access range property, no key required. All members/visitors are still required to sign in on the range use log book located in the clubhouse.
3. The primary member will be issued and RFID access card, your photo ID and membership card/gate access will be combined into one card. Family members will be issued a photo ID card but it will NOT open the gate.
Lost access cards will be subject a $30 fee for replacement/processing.
Primary MEMBERS ARE PERMITTED TO TAKE A MAXIMUM OF TWO GUESTS ALONG.A GUEST PASS MUST BE PURCHASED EACH TIME (Again, an insurance fee is paid by the club for guests). Members who are discovered to be loaning out access card or not properly documenting and paying guest pass fees will LOSE ALL MEMBERSHIP PRIVLEDGES WITHOUT NOTICE OR REFUND. It is the responsibility of the Primary member to ensure that guests abide by all club rules/pay the proper fee ($20.00) and behave themselves while on range property. If your guest is found to be acting in an unsafe manner, causing a disturbance to other club members or not abiding by club policies you will lose your membership!
RANGE K TRAP MACHINE SAFETY ORIENTATION
Members will now be able to take a safety orientation for use of the electric trap machine.
Members who complete the orientation will be issued a key and an orientation card.
Keep these with your ID badge holder.
Only members who have completed the orientation will be permitted to start-up and load the machine.
CHECK THE CALENDAR FOR ORIENTATION DATES AND TIMES